Console Port Connector Pinouts For Mx150; Table 17: Console Port Connector Pinouts For The Mx150 - Juniper MX150 Hardware Manual

MX150 3D Universal Edge Router Hardware Guide
Table 16: Mini-USB Type-B Console Port Pinout Information for MX150 (continued)
Pin Signal
4 GND
Related
Documentation

Console Port Connector Pinouts for MX150

Related
Documentation
32
MX150 Router Overview on page 3
Configuring the Console Port Type (CLI Procedure)
The console port (labeled
CON
to connect to a console management device. The default baud rate for the console port
is 9600 baud.
Table 17 on page 32 provides the pinout information for the RJ-45 console connector. An
RJ-45 cable and RJ-45 to DB-9 adapter are supplied with the MX150 device.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to an MX150 device, use a
combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with the
device and a USB to DB-9 male adapter. You must provide the USB to DB-9
male adapter.

Table 17: Console Port Connector Pinouts for the MX150

Pin
1
2
3
4
5
6
7
8
Connecting an MX150 to a Management Console on page 90
Description
Ground
) is an RS-232 serial interface that uses an RJ-45 connector
Signal
RTS Output
DTR Output
TxD Output
Signal Ground
Signal Ground
RxD Input
DCD Input
CTS Input
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Clear to send
Copyright © 2017, Juniper Networks, Inc.