Advertisement
CHAPTER 13
Initially Configuring the MX150
Configuring the MX150
Copyright © 2017, Juniper Networks, Inc.
Configuring the MX150 on page 93
You must perform the initial configuration of the MX150 through the console port using
the command-line interface (CLI).
Before you begin connecting and configuring an MX150, set the following parameter
values on the console server or PC:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
Stop Bits—1
DCD State—Disregard
To connect and configure the device from the console:
Connect the console port to a laptop or PC by using the supplied RJ-45 cable and
1.
RJ-45 to DB-9 adapter. The console (
of the device.
Start the CLI.
2.
root@host% cli
Enter configuration mode.
3.
root@host> configure
Add a password to the root administration user account.
4.
[edit]
root@host# set system root-authentication plain-text-password
New password: password
Retype new password: password
) port is located on the management panel
CON
93
Advertisement
Chapters
