Installing The New 4 X 2.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX1330 M3 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY RX1330 M3:
Table of Contents

Advertisement

Right side 4 x 2.5-inch HDD backplane (A3C40196777)
Figure 69: Removing the 4 x 2.5-inch HDD backplane
Ê Disconnect all cables from the HDD backplane (see orange arrows).
I
If applicable, remove the OOB cable from the HDD backplane, too.
Ê Pull the HDD backplane upward until the four hooks disengage (see circles).
Ê Take out the HDD backplane.
7.2.8.3

Installing the new 4 x 2.5-inch HDD backplane

I
For configurations with up to four 2.5-inch HDDs/SSDs, please refer to:
section
"Right side 4 x 2.5-inch HDD backplane (A3C40196777)" on
page
154.
For configurations with up to eight 2.5-inch HDDs/SSDs, please refer to:
section
"Right side 4 x 2.5-inch HDD backplane (A3C40196777)" on
page 154
or
page
155.
RX1330 M3
Hard disk drive (HDD) / solid state drive (SSD)
"Left side 4 x 2.5-inch HDD backplane (A3C40196780)" on
Upgrade and Maintenance Manual
153

Advertisement

Table of Contents
loading

Table of Contents