Installing The New Hot-Plug Psu; Concluding Steps; Replacing The Power Distribution Board; Preliminary Steps - Fujitsu PRIMERGY RX1330 M3 Upgrade And Maintenance Manual

6.3.3.3

Installing the new hot-plug PSU

Ê Install the PSU as described in section
page 110.
6.3.3.4

Concluding steps

Ê Connect the power cord to the new PSU and secure it with a cable tie as
described in section
Ê Only when replacing a PSU in a non-redundant configuration:
the server" on page 66
"Performing a fan test" on page 101
Ê
6.3.4

Replacing the power distribution board

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
6.3.4.1

Preliminary steps

"Locating the defective server" on page 50
Ê
"Suspending BitLocker functionality" on page 71
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting the power cord" on page 54
Ê
"Getting access to the component" on page 55
Ê
RX1330 M3
"Connecting the power cord" on page
Upgrade and Maintenance Manual
Power supply unit (PSU)
"Installing a hot-plug PSU" on
Hardware: 15 minutes
64.
"Switching on
117