Power supply unit (PSU)
6.4.2.3
Installing the dummy cover
Figure 42: Installing the dummy cover
Ê Insert the dummy cover into the empty bay with the impressed arrow symbol
facing to the top (see circle).
Ensure that the upper rear cant of the dummy cover fits under the PSU cage.
Ê Push the dummy cover into its bay until it locks in place.
V
CAUTION!
Always install dummy covers into unused bays to comply with
applicable EMC regulations and satisfy cooling requirements.
6.4.3
Replacing the FJBU
Customer Replaceable Unit
(CRU)
Tools: tool-less
Note for servers using CMA (Cable Management Arm)
Regarding of replacing the FJBU, additional tasks are needed, due to an
interference between CMA stopper and the FJBU.
Ê Push the lock spring inward to unlock the CMA stopper (see figure 31).
V
CAUTION!
In case of not enough space at the under side, unlock the CMA
stopper of the server below and pull out the CMA to the rear side
124
Upgrade and Maintenance Manual
Hardware: 5 minutes
RX1330 M3