Concluding Steps - Fujitsu PRIMERGY RX1330 M3 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state drive (SSD)
Figure 72: Connecting the cables to the ODD and the 4 x 2.5-inch HDD backplane
Ê If applicable, push the ODD in its bay until the ODD latch engages (see
orange arrow).
Ê Connect the following cables to the ODD and the HDD backplane:
– (1) power cable to ODD (if applicable)
– (2) SATA cable to ODD (if applicable)
– (3) SAS cable to connector "X5" on the HDD backplane
– (4) power cable to connector "X10" on the HDD backplane
I
If applicable, connect the OOB cable to connector "SMBus" on the
HDD backplane.
For the cable plan see section
7.2.8.4

Concluding steps

Ê Insert all HDD/SSD modules, see section
modules" on page
I
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
"Reassembling" on page 60
Ê
"Connecting the power cord" on page 64
Ê
"Switching on the server" on page 66
Ê
156
"Cabling plans" on page
144.
Upgrade and Maintenance Manual
312.
"Installing 2.5-inch HDD/SSD
RX1330 M3