Switching On The Server; Handling Riser Modules; Removing A Riser Module - Fujitsu PRIMERGY RX1330 M3 Upgrade And Maintenance Manual

Basic hardware procedures
4.7

Switching on the server

V
CAUTION!
Before switching on the server, make sure the top cover is closed. In
●
order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top cover is removed.
For further safety information, please refer to chapter
●
information" on page
Ê Press the On/Off button to start up the server.
Ê Ensure that the power-on indicator above the On/Off button is lit green.
Ê Perform the required procedures described in the concluding steps of each
upgrade or maintenance task.
4.8

Handling riser modules

4.8.1

Removing a riser module

Figure 12: Removing the riser module 1
66
35.
Upgrade and Maintenance Manual
"Important
RX1330 M3