Table 7-19 Adsl Module - Siemens hipath 1100 Service Manual

Configuring the System Specifically for the Client
Table of the System's Programming Codes
ADSL Module
Table 7-19 ADSL Module
Programmed Cod
Functions e
Restore ADSL 013
module default
settings
Relay and sensor on the HiPath 1120
Table 7-20 Relay and sensor on the HiPath 1120
Programmed Cod
Functions e
Sensor function 70
configuration
Sensor activation 74
logic
Time between 050
Attempts for Acti-
vating the Sensor
MSN Assignment 051
for the Sensor
Number Dialed by 052
Sensor Activation
Number of 053
Attempts for Acti-
vating the Sensor
DTMF signals for 77
the Relay
7-20
Intermediate Data
Intermediate Data
Data to be
Programmed
Data to be
Programmed
0 = Deactivate the sensor's
function (default)
1 = Dial the number speci-
fied in "Number Dialed by
Sensor Activation" (Code
052).
2 = Activate the relay
through the sensor
3 = Detect DTMF code.
When this setting is
selected, the number that
was called must acknowl-
edge or ignore an alarm call
by sending an acknowl-
edgement code ("#" DTMF
signal)
0 - Contacts closed
1 - Contacts open
Time: 00 to 10 minutes
Slot: 001 to 140 or
∗ −
To delete
Number (up to 20 digits)
001 to 100 (attempts)
Number (up to 20 digits)
# - To confirm
A31003-K1250-S100-12-7619
For internal distribution only
Completing Default
Data Entry
Automatic IP 10.0.0.1
Completing Default
Data Entry
Automatic 0
# instead of the 0 - Contacts
sensor closed
Automatic 03 (3 minutes)
Automatic None
Automatic or None
#
Automatic 001 (1
attempt)
Automatic None
HiPath 1100, Service Manual