Siemens hipath 1100 Service Manual page 206

Configuring the System Specifically for the Client
Comments about the System's Programming Codes
Default Access to a Group of External Lines (002)
This setting determines how each extension will access a group of external lines.
If the user enters an external access code of "0," the system will search for a free
line in the group assigned. If there is no free line, the system will search for a line in
another group.
Analog Line Attendants (42)
These define the extensions or Consecutive Groups that will first answer calls re-
ceived from a specific external line during a specified time period (Day/Night).
If an extension is connected to a Door Opener device, the device cannot be config-
ured as an Attendant.
When no first DID is configured, the call will be forwarded to the Overflow exten-
sion. In the event that an Overflow extension is not configured, the call will end. In
such cases no extension is signaled and the call cannot be captured. Meanwhile, the
system will continue to wait for an available external line.
Speed Dialing/Phonebook (12)
You can store up to 250 telephone numbers of up to 20 digits each in the System
Speed Dialing. You can assign a name of up to 10
characters to each number. This allows you to do alphanumeric searches (see the
section on Alphanumeric Search in the User Manual).
You can look for phone numbers in the Speed Dial Phonebook by entering their as-
signed speed-dial number. This can be done from any extension. By default there are
no speed-dial numbers stored in the Phonebook.
For the HiPath 1120, the Phonebook entry 249 is reserved for relay and sensor func-
tions.
To dial an external number enter the external line number instead of the external ac-
cess code "0."
Denied Numbers List (23)
There are 3 Denied Numbers Lists valid for all extensions in the category "Restricted
Trunk Access (with Denied List)" . List 1 allows you to store 4 numbers; list 2, up to 10
numbers; and list 3 up to 35 numbers.
To change a blocked number enter its Phonebook entry number then the new num-
ber.
7-22
For internal distribution only
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual