Installing A Power Supply - Siemens hipath 1100 Service Manual

For internal distribution only

4.6.8 Installing a Power Supply

Introduction
Before connecting the power supply to the system, see "Technical Data" on page 2-
7 " and "Power Supply Unit (PSU)" on page 3-43.
On the HiPath 1120
●
Figure 4-24
Procedure after Installation
Step
1.
2.
3.
4.
Warning
!
To turn the power on or off to the system use the power supply's cable.
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Installing a Power Supply HiPath 1120
Procedure
Check network voltage
If the voltage is within the power supply's voltage range, connect the
power supply.
"Performing a Visual Inspection" on page 4-48
Configure the required data (see "Operation" on page 6-1).
Installation of Expansion and Option Modules
Installation
4-29