Installation
Installation of Expansion and Option Modules
4.6.3 Installing a S0 Module
Warning
!
For proper system synchronization make sure to connect S
For example, for a 5-interface module with only 2 S
to the first interface and NT2 to the second interface. The clock reference is only pro-
vided by the S
4.6.4 Installing a TME1 Module
Warning
!
Remember to set the DIP switches (see"TME1 Module" on page 3-27).
4.6.5 Installing an ADSL Module
Installation Procedures
Step
1.
2.
3.
4.6.6 Installing a Fax/DID Module
On the HiPath 1120
●
Installation Procedures
Step
1.
2.
3.
4.
5.
4-24
module's first interface.
0
Procedure
Connect the carrier's ADSL line to slot 1 and 2 of the X2 connector (voice
output).
In the CND version, connect the carrier's ADSL line to slot 1 of the X2 con-
nector.
Connect slots 3 and 4 of the X2 connector to the external line input for
the HiPath 1100. 99 slots
In the CND version, connect to slot 2 of the X2 connector.
Connect your network cables to the HUB (J3, J5, J6 and J7 connectors).
Procedure
Turn off the power supply.
Remove the system's cover
Attach the separator provided with the module to the MB.
Attach the module to the MB's pin connector and to the separator.
Reassemble the entire set.
For internal distribution only
interfaces sequentially.
0
lines NT1 must be connected
0
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual