Operation; Connecting The System To The Power Supply; Updating The Software - Siemens hipath 1100 Service Manual

For internal distribution only

6 Operation

This chapter describes the procedures for powering up and initializing the systems.
Warning
!
Powering up and initializing the system is a task that must be performed only by au-
thorized technical personnel.
This chapter covers the following topics:
Step
1.
2.
3.

6.1 Connecting the System to the Power Supply

Procedure
Step
1.
2.
3.

6.2 Updating the Software

If your computer already has a version of the HiPath 1100 software installed, you may
update it with the latest version.
The software update for version 5.2 uses version 5.1 update (from version 3.4) for up-
dating version 5.1 to version 5.2.
In the first window of the 5.2 software update you will be asked if you are updating
your software from version 5.1 to version 5.2. If so, the 5.1 software update will be
invoked by the APS and a message will be displayed indicating the conversion re-
quired for the database backup file.
To update to a more recent version than the one already provided, the process must
be repeated. On the second time the software update will run as it usually does (that
is, it will not call the 5.1 update), and you will be able to load the latest version.
To retrieve the database backup from 5.1 and update it to 5.2 you must use version
5.2 HiPath 1100 Manager.
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Action (Instructions)
Connecting the system to the power source
(Connecting the power cable ->Initializing the system).
Updating the Software.
Starting the Programming Mode.
Procedure
Complete installation of all modules (Chapter 4, "Installation").
Plug in power cord
Wait a few moments for the system to load the software.
Connecting the System to the Power Supply
Operation
page 6-1
page 6-1
page 6-2
6-1