Siemens hipath 1100 Service Manual page 213

For internal distribution only
Ring Signal Time at an Agent (030)
This setting specifies how long an incoming call will keep on ringing at an agent's sta-
tion.
Time in a UCD Queue (031)
This setting specifies the maximum length of time a call is allowed to remain in a UCD
Queue.
Once the time expires the call is disconnected or forwarded to a UCD overflow call
extension.
Waiting Message before Signaling a UCD Call (032)
This feature allows you to connect a call waiting message for incoming calls before
they ring at an extension.
Minimum Time for Call Waiting Message in a UCD Queue (033)
This setting specifies a minimum length of time until a message is played for calls
waiting in a queue.
Hunt Groups (HG) (021)
This setting allows you to group extensions into a maximum of 10 Hunt Groups (780
to 789).
A Hunt Group (HG) is a group of extensions assigned for answering calls made to a
specific number.
When an extension does not answer an internal or external call within a specified pe-
riod of time, the call rings consecutively at the available and the busy extensions in
the group. When no one is not available, the extension may disconnect from the Hunt
Group.
Search Mode for Hunt Groups (022)
This setting specifies the type of search to be performed for an available extension
within a group, whether linear or round-robin.
When a call is received by a Hunt Group configured for Linear distribution, the search
starts from the first extension within the group. In a Round-robin distribution the
search starts from the extension following the last extension selected.
Override (44)
This setting allows a specific extension to "Override" two other extensions with a
conversation in progress.
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Configuring the System Specifically for the Client
Comments about the System's Programming Codes
7-29