4
Install the communication unit in the extension interface of the GOT rear face.
(When the extension unit is installed in GOT, remove the installed extension unit. And, do not
touch the board in the GOT when install the communication unit.)
5
After the installation, tighten the mounting screws (4 places) in the specified torque range (0.36
to 0.48N·m).
6
Tighten the extend interface relay board installed by the step
range (0.36 to 0.48N·m). (2 places)
7
7.1 Communication Unit
- 5
7.1.2 Installing procedure
Removing the GT15-QBUS2, GT15-ABUS2
Before removing the unit, unscrew the extend interface relay board fixing screws.
(
)
above
within the specified torque