Mitsubishi Electric GT1695M-XTBD User Manual page 443

Error
Error message
code
Error in specified PLC
357
drive Confirm PLC drive
PLC file access failure.
358
Confirm PLC drive.
Processing from another
359 peripheral device.
Execute it after.
0 divisor division error.
360 Confirm operation
expression.
Specified device No. is
361
out of range.
Invalid device value in
362
time action setting
Upper and lower limit
370 value error. Confirm value
setting.
Insufficient USB drive
capacity.
380
Confirm the drive
capacity.
USB drive is not installed
381
or in a removable state.
USB drive is not
382
formatted.
Unable to overwrite. USB
383
drive is write-protected
Action
When executing the recipe function specifying the file register
name, error occurred in PLC CPU drive.
1. Execute the recipe function again after confirming the
specified PLC CPU drive.
2. Execute the recipe function again after formatting the PC
memory in the specified PLC CPU drive with GX
Developer.
When the recipe function is executed specifying the file
register name, PLC CPU file register could not be accessed.
1. Execute the recipe function again after confirming the
specified PLC CPU drive / file register name. (When you
specify drive 0, execute the recipe function again after
changing to other drives.)
2. Confirm whether the CF card or USB memory are write-
protected, and execute the recipe function again.
When the recipe function is executed specifying the file
register name, other peripherals carry out the process to the
file register.
Wait until the processing of other peripherals end, and
execute the recipe function again.
Zero division occurred by the data operational expression.
Review the data operational expression so that the divisor
should not become 0.
The entered file number is out of range.
Check the entered file number, and enter a valid value (1 to
9999).
When controllers are controlled with the GOT's time action
function, the set No. is our of range, or the set device values
regarding the operation settings are out of range or invalid.
Set valid values.
The setting of lower/upper limit value is [Upper limit < Lower
limit].
Correct the setting so as to be "Upper limit
Available memory of the USB memory is insufficient.
Confirm the available memory of the USB memory, and
increase the memory if it is low.
If the USB memory is not installed, install it.
If the USB memory is ready to be removed, install it again.
Memory card is not formatted or in a format not conformed by
a GOT.
Reformat the USB memory.
USB memory is write-protected.
Cancel the write-protection of USB memory.
16.3 Error Message and System Alarm
16.3.2 List of error message/system alarm
Channel
No.
storage
Lower limit".
16
- 22
9
10
11
12
13
14
15
16