Mitsubishi Electric GT1695M-XTBD User Manual page 419

5 The model and the production year and month are printed on the back of a backlight.
H01 or H02 is printed after the model.
H01 indicates the upper backlight, and H02 indicates the lower backlight
6 Remove the cable connectors of the upper backlight (H01) and the cable connectors of the lower
backlight (H02) from the GOT connectors.
7 Pull out the upper backlight from the backlight replacement hole on the upper part of the GOT.
Pull out the lower backlight from the backlight replacement hole on the lower part of the GOT.
8 When pulling out the backlight with pushing it toward the center of the GOT, the projection of the rubber
holder is unfixed and the backlight can be easily pulled out.
9 Install a new backlight in the reverse procedure of removal.
When inserting a new backlight into the backlight replacement hole of the GOT, make sure not to
damage the sheaths of the cables.
Insert the backlight until the projection of the rubber holder is fixed.
Assemble the case in the reverse procedure of disassembly. (Tighten the fixing screws on the GOT rear
face with a torque of 0.36 to 0.48N•m).
When installing the case, make sure that the cables are not stuck between the case and the GOT.
Top
H01
Bottom
H02
B
Hole for backlight replacement
A jut of the rubber holder
15.6.2 Replacement procedure of backlight
15.6 Backlight Replacement
9
10
11
12
13
14
15
16
15
- 7