Mitsubishi Electric GT1695M-XTBD User Manual page 453

Error
Error message
code
Abnormal cyclic
802
transmission status
803 Transient error
The cable on the IN side
804 is disconnected or is not
connected.
The cable on the OUT
805 side is disconnected or is
not connected.
CC-Link switch setting
850
error
Abnormal cyclic
851
transmission status
852 Abnormal host line status
853 Transient error
*1 When an error occurs, "FF
Refer to explanations of SB0049 on the applicable network
manual.
Refer to explanations of SB00EE on the applicable network
manual.
Refer to explanations of SB0067 on the applicable network
manual.
Refer to explanations of SB0068 on the applicable network
manual.
1. Check if the switch settings have no error.
2. Check error codes stored in SW006A.
3. Refer to explanations of SB006A on the applicable
network manual.
1. Check if terminating resistors are connected.
2. Check error codes for the PLC CPU.
3. Check the parameter for the PLC CPU on the master
station.
4. Check the error status of the master station.
5. Refer to explanations of SB006E on the applicable
network manual.
1. Check if the cable is unplugged or not.
2. Refer to explanations of SB0090 on the applicable
network manual.
1. Check the transient error occurrence status for each
station stored in SW0094 to SW0097.
2. Refer to explanations of SB0094.
" is stored to the channel No.
H
16.3 Error Message and System Alarm
16.3.2 List of error message/system alarm
Action
9
Channel
No.
storage
10
11
12
13
14
15
16
16
- 32