Mitsubishi Electric GT1695M-XTBD User Manual page 28

* 1
* 2
1
1.2 Rough Pre-operation Procedure
- 6
By connecting with the Ethernet interface included as standard in GT 16, project data can be downloaded/
uploaded.
For download/upload of project data with the Ethernet connection, BootOS and standard monitor OS should be
installed in the GOT in advance so that the GOT and PC can communicate with each other via Ethernet by
setting Communication Settings.
Refer to the following manual for details.
GT Designer2 Version
The B drive or E drive cannot be set as the OS boot drive.
Precautions for setting OS boot drive to [A: Standard CF Card]
(1) GOT startup time
When the OS boot drive is set to [A: Standard CF Card], the GOT startup time with
the A drive takes longer than that with the C drive.
The GOT startup time with the A drive differs depending on the CF card type, the
numbers of extended function OSs and option OSs, and project data size.
(2) Handling CF card during booting OS
Do not remove the CF card and do not turn off the CF card access switch during
booting the OS.
Doing so causes the boot to fail. As a result, the GOT does not start correctly.
(3) Corrective actions when OS cannot be booted
The OS cannot be booted in the following conditions.
Take the following corrective actions, and then boot the OS again.
The type of the GOT to be used differs from the
GOT type data set with GT Designer2 stored in
the CF card.
The GOT has insufficient memory.
The CF card access switch is off.
Basic Operation/Data Transfer Manual (Chapter 8 TRANSFERRING DATA)
Condition Corrective action
Prepare the CF card where the OSs and project data
of the same GOT type as the GOT to be used are
written.
Delete unnecessary data stored in the memory of
GOT.
For details, refer to the following manual.
GT Designer2 Version
Data Transfer Manual
Turn on the CF card access switch.
Basic Operation/