Mitsubishi Electric GT1695M-XTBD User Manual page 68

2 Since the battery is stored, insert the battery connector into the connector of the GOT.
3 Insert the GOT into the panel opening from the front side.
GOT
4 Place the mounting fixtures (included with GOT) on the mounting fixture attaching part of the GOT, and
fix them by tightening the mounting screws in the torque range of 0.36 to 0.48N·m.
(Failure to do so may distort the panel and make a surface waviness on the protective sheet.)
For GT1695: Fix the GOT with 8 mounting fixtures.
5 A protection film is attached on the display section of GOT prior to shipment.
Remove the film when the installation is compelted.
Remove the protective film of the GOT.
When the user continues using the GOT with the protective film, the film may not be removed.
5
5.5 Installation Procedure
- 8
Panel opening
Magnified figure
For other then GT1695: Fix the GOT with 4 mounting fixtures.
Magnified figure