Lldp Timer Tx-Interval; Lldp Tlv-Enable - HP 3600 v2 Series Command Reference Manual

It is a good practice to set the LLDPDU transmit delay to be no greater than a quarter of the LLDPDU
transmit interval.
If the LLDPDU transmit delay is greater than the LLDPDU transmit interval, the device uses the LLDPDUs
transmit delay as the transmit interval.
Related commands: lldp timer tx-interval.
Examples
# Set the LLDPDU transmit delay to 4 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-delay 4

lldp timer tx-interval

Syntax
lldp timer tx-interval interval
undo lldp timer tx-interval
View
System view
Default level
2: System level
Parameters
interval: Sets the LLDPDU transmit interval, ranging from 5 to 32768 seconds.
Description
Use lldp timer tx-interval to set the LLDPDU transmit interval.
Use undo lldp timer tx-interval to restore the default.
By default, the LLDPDU transmit interval is 30 seconds.
It is a good practice to set the LLDPDU transmit interval to be no less than four times the LLDPDU transmit
delay.
If the LLDPDU transmit interval is less than the LLDPDU transmit delay, the device uses the LLDPDUs
transmit delay as the transmit interval.
Related commands: lldp timer tx-delay.
Examples
# Set the LLDPDU transmit interval to 20 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-interval 20

lldp tlv-enable

Syntax
In Layer 2 Ethernet interface view or port group view:
lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] } |
258