Link-Aggregation Load-Sharing Mode - HP 3600 v2 Series Command Reference Manual

Description
Use link-aggregation lacp traffic-redirect-notification enable to enable link-aggregation traffic
redirection.
Use undo link-aggregation lacp traffic-redirect-notification enable to disable link-aggregation traffic
redirection.
By default, link-aggregation traffic redirection is disabled.
Link-aggregation traffic redirection applies only to dynamic link aggregation groups.
To prevent traffic interruption, enable link-aggregation traffic redirection on devices at both ends of the
aggregate link.
Do not enable both MSTP and link-aggregation traffic redirection at the same time, because light packet
loss may occur when the device reboots.
After link-aggregation traffic redirection is enabled, do not add an Ethernet interface configured with
physical state change suppression to an aggregation group. Otherwise, Selected ports in the
aggregation group might work improperly. For more information about physical state change
suppression, see the link-delay command in
Examples
# Enable link-aggregation traffic redirection.
<Sysname> system-view
[Sysname] link-aggregation lacp traffic-redirect-notification enable

link-aggregation load-sharing mode

Syntax
In system view:
link-aggregation load-sharing mode { destination-ip | destination-mac | destination-port |
ingress-port | source-ip | source-mac | source-port } *
undo link-aggregation load-sharing mode
In Layer 2 aggregate interface view:
link-aggregation load-sharing mode { destination-ip | destination-mac | source-ip | source-mac } *
undo link-aggregation load-sharing mode
View
System view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
destination-ip: Performs load sharing in link aggregation groups based on destination IP address.
destination-mac: Performs load sharing in link aggregation groups based on destination MAC address.
destination-port: Performs load sharing in link aggregation groups based on destination port.
ingress-port: Performs load sharing in link aggregation groups based on ingress port.
source-ip: Performs load sharing in link aggregation groups based on source IP address.
"Ethernet interface configuration
92
commands."