View
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default level
2: System level
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode only receives LLDPDUs.
tx: Specifies the Tx mode. A port in this mode only sends LLDPDUs.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Description
Use lldp admin-status to specify the LLDP operating mode for a port or all ports in a port group.
Use undo lldp admin-status to restore the default LLDP operating mode.
By default, the LLDP operating mode is TxRx.
Examples
# Configure the LLDP operating mode as Rx for Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp admin-status rx
lldp check-change-interval
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
View
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default level
2: System level
Parameters
interval: Sets the LLDP polling interval, ranging from 1 to 30 seconds.
Description
Use lldp check-change-interval to enable LLDP polling and set the polling interval.
Use undo lldp check-change-interval to restore the default.
By default, LLDP polling is disabled.
Examples
# Enable LLDP polling on Ethernet 1/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp check-change-interval 30
250