Mtu; Port Link-Aggregation Group - HP 3600 v2 Series Command Reference Manual

Executing this command may cause all the member ports in the aggregation group to become
unselected.
The minimum numbers of Selected ports for the local and peer aggregation groups must be consistent.
Examples
# Configure the minimum number of Selected ports as 3 in the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port minimum 3

mtu

Syntax
mtu size
undo mtu
View
Layer 3 aggregate interface view
Default level
2: System level
Parameters
size: Specifies the maximum transmission unit (MTU) in bytes. This argument ranges from 46 to 1560.
Description
Use the mtu command to set the MTU of a Layer 3 aggregate interface.
Use the undo mtu command to restore the default setting.
By default, the MTU for Layer 3 aggregate interfaces is 1500 bytes.
Related commands: display interface.
Examples
# Set the MTU of Layer 3 aggregate interface Route-Aggregation 1 to 1430 bytes.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1] mtu 1430

port link-aggregation group

Syntax
port link-aggregation group number
undo port link-aggregation group
View
Ethernet interface view
Default level
2: System level
97