Isolated-Vlan Enable - HP 3600 v2 Series Command Reference Manual

View
VLAN view
Default level
2: System level
Parameters
None
Description
Use isolate-user-vlan enable to configure the VLAN as an isolate-user-VLAN.
Use undo isolate-user-vlan enable to remove the isolate-user-VLAN configuration for the VLAN.
By default, no VLAN is an isolate-user-VLAN.
An isolate-user-VLAN may include multiple ports, including the one connected to the upstream device.
Do not configure the default VLAN (VLAN 1) as a secondary VLAN or isolate-user-VLAN.
Related commands: display isolate-user-vlan.
Examples
# Configure VLAN 5 as an isolate-user-VLAN.
<Sysname> system-view
[Sysname] vlan 5
[Sysname-vlan5] isolate-user-vlan enable

isolated-vlan enable

Syntax
isolated-vlan enable
undo isolated-vlan enable
View
VLAN view
Default level
2: System level
Parameters
None
Description
Use isolated-vlan enable to configure Layer 2 isolation between ports in the same secondary VLAN.
Use undo isolated-vlan enable to restore the default.
By default, ports in the same secondary VLAN can communicate at Layer 2.
You cannot configure Layer 2 isolation between ports in an isolate-user-VLAN.
Layer 2 isolation configured with the isolated-vlan enable command takes effect only when each port in
the secondary VLAN is configured to operate in host mode and the secondary VLAN is associated with
an isolate-user-VLAN.
198