Stp Tc-Snooping - HP 3600 v2 Series Command Reference Manual

View
System view
Default level
2: System level
Parameters
number: Sets the maximum number of immediate forwarding address entry flushes that the device can
perform within a certain period of time (10 seconds). The value ranges from 1 to 255.
Description
Use stp tc-protection threshold to configure the maximum number of forwarding address entry flushes
that the device can perform every a certain period of time (10 seconds).
Use undo stp tc-protection threshold to restore the default.
By default, the device can perform a maximum of six forwarding address entry flushes every 10 seconds.
Examples
# Configure the device to perform up to 10 forwarding address entry flushes every 10 seconds.
<Sysname> system-view
[Sysname] stp tc-protection threshold 10

stp tc-snooping

Syntax
stp tc-snooping
undo stp tc-snooping
View
System view
Default level
2: System level
Parameters
None
Description
Use stp tc-snooping to enable topology change (TC) snooping.
Use undo stp tc-snooping to disable TC snooping.
By default, TC snooping disabled.
TC snooping and STP are mutually exclusive. Before enabling TC snooping, first disable STP globally.
TC snooping does not take effect on the ports on which BPDU tunneling is enabled for STP. For more
information about BPDU tunneling, see Layer 2—LAN Switching Configuration Guide.
Related commands: stp enable.
Examples
# Enable TC snooping globally.
<Sysname> system-view
145