Stp Port Priority - HP 3600 v2 Series Command Reference Manual

Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
When connecting to a non-point-to-point link, a port is incapable of rapid state transition.
You can configure the link type as point-to-point for a Layer 2 aggregate interface or a port that operates
in full duplex mode. HP recommends that you use the default setting, which lets the device automatically
detect the port link type.
The stp point-to-point force-false or stp point-to-point force-true command configured on a port in MSTP
or PVST mode takes effect on all MSTIs or VLANs.
If the physical link to which the port connects is not a point-to-point link but you set it to be one, the
configuration may bring a temporary loop.
Related commands: display stp.
Examples
# Configure the link connecting Ethernet 1/0/3 as a point-to-point link.
<Sysname> system-view
[Sysname] interface ethernet 1/0/3
[Sysname-Ethernet1/0/3] stp point-to-point force-true

stp port priority

Syntax
stp [ instance instance-id | vlan vlan-list ] port priority priority
undo stp [ instance instance-id | vlan vlan-list ] port priority
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
instance instance-id: Sets the priority of the ports in a particular MSTI. The value of instance-id ranges
from 0 to 32, where 0 represents the CIST.
priority: Specifies a port priority, in the range of 0 to 240 in steps of 16 (as in 0, 16, 32).
vlan vlan-list: Specifies a VLAN list in the format of vlan-list = { vlan-id [ to vlan-id ] }&<1- 1 0>, where the
vlan-id argument represents the VLAN ID, in the range of 1 to 4094, and &<1- 1 0> indicates that you can
specify up to 10 VLAN IDs or VLAN ID ranges.
Description
Use stp port priority to set the priority of the ports.
Use undo stp port priority to restore the default.
By default, the port priority is 128.
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
138