HP 3600 v2 Series Command Reference Manual page 15

Port priority: 0
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 10000
Peak value of input: 0 bytes/sec, at 2010-01-01 02:06:26
Peak value of output: 0 bytes/sec, at 2010-01-01 02:06:26
Last 300 seconds input:
Last 300 seconds output:
Input (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts,
Input (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts,
Output (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors,
0 aborts,
0 lost carrier, - no carrier
Table 3 Command output
Field
Ethernet1/0/1 current state
Line protocol current state
Description
Internet protocol processing
Media type is
loopback not set
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
0 multicasts, 0 pauses
0 multicasts, 0 pauses
- underruns, - buffer failures
0 deferred, 0 collisions, 0 late collisions
Description
State of the Ethernet interface:
•
DOWN ( Administratively )—The Ethernet interface was shut down with
the shutdown command. The interface is administratively down.
•
DOWN ( Link-Aggregation interface down )—The Ethernet interface is
physically down because the aggregate interface corresponding to the
aggregation group to which the Ethernet interface belongs was shut
down with the shutdown command.
•
DOWN—The Ethernet interface is administratively up but physically
down (possibly because no physical link is present or the link has failed).
•
UP—The Ethernet interface is both administratively and physically up.
Link layer state of the interface:
•
DOWN—The interface is physically down.
•
UP—The interface is physically up.
Description of the Ethernet interface.
Disabled indicates that IP packets cannot be processed.
For an interface configured with an IP address, this field changes to Internet
Address is.
Physical medium, twisted pair or optical fiber.
The loopback testing function is disabled.
For an interface configured with the loopback external or loopback internal
command, this field changes to loopback is set.
7