Display Vlan - HP 3600 v2 Series Command Reference Manual

Field
Last clearing of counters
Last 300 seconds input: 0 bytes/sec
0 packets/sec
Last 300 seconds output: 0 bytes/sec
0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
The brief information of interface(s)
under route mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
Cause

display vlan

Syntax
display vlan [ vlan-id1 [ to vlan-id2 ] | all | dynamic | reserved | static ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Description
Time when the reset counters interface vlan-interface command was
last used to clear the interface statistics.
Never indicates the reset counters interface command has never been
used on the interface since the device's startup.
Average rate of input packets in the last 300 seconds (in bps and pps).
Average rate of output packets in the last 300 seconds (in bps and
pps).
Total number and size (in bytes) of the received packets of the interface
and the number of the dropped packets.
Total number and size (in bytes) of the sent packets of the interface and
the number of the dropped packets.
Brief information about Layer 3 interfaces.
Link layer state of the interface:
•
ADM—The interface has been administratively shut down. To
recover its physical state, perform the undo shutdown command.
•
Stby—The interface is operating as a standby interface.
If the network layer protocol state of an interface is shown as UP, but its
link is an on-demand link or not present at all, its protocol attribute
includes the spoofing flag (an s in parentheses).
Abbreviated interface name.
Physical link state of the interface:
•
UP—The link is up.
•
ADM—The link has been administratively shut down. To recover its
physical state, perform the undo shutdown command.
Protocol connection state of the interface, which can be UP, DOWN,
or UP(s).
Main IP address of the interface.
Description of the interface.
Cause of a DOWN physical link. If the port has been shut down with
the shutdown command, this field displays Administratively. To restore
the physical state of the interface, use the undo shutdown command.
159