Port Auto-Power-Down - HP 3600 v2 Series Command Reference Manual

If you execute this command in Ethernet interface view, the configurations take effect only on the interface.
If you execute this command in port group view, the configurations take effect on all ports in the port
group.
When you configure the multicast suppression threshold in kbps, if the input value is less than 64, the
value that takes effect is 64; if the input value is greater than 64 but is not a multiple of 64, the value that
takes effect is a multiple of 64 greater than and nearest to the input value.
When multicast traffic exceeds the threshold you configure, the system discards multicast packets until the
multicast traffic drops below the threshold.
NOTE:
If you set different multicast suppression thresholds in Ethernet interface view or port group view multiple
•
times, the one configured last takes effect.
For a particular type of traffic, configure either storm suppression or storm control, but not both. If both
•
of them are configured, you may fail to achieve the expected storm control effect.
Examples
# Set the multicast threshold to 20% on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] multicast-suppression 20
# Set the multicast threshold to 20% on all ports in the port group named group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member ethernet 1/0/1
[Sysname-port-group-manual-group1] group-member ethernet 1/0/2
[Sysname-port-group-manual-group1] multicast-suppression 20
# Set the multicast suppression threshold to 10000 kbps on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] multicast-suppression kbps 10000
Info: The actual value is 10048 on this port currently.

port auto-power-down

Syntax
port auto-power-down
undo port auto-power-down
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
39