Local While Armed; Disable Restorals - Bosch B9512G Program Entry Manual

Control Panel
–
–
Use this parameter to allow a controlled point to report alarms, troubles and restoral reports
only when the area is armed.
Notice!
A restoral report is transmitted even when the area is disarmed if the alarm or trouble event
occurred while the area was armed and returned to normal after the area was disarmed.
This parameter suppresses all reports from 24-hour points. Do not use this parameter with
Point Type set to 24-Hour. This parameter only works for disarmed points, and a 24 hour
"always armed" point. Instead, choose any type other than 24-Hour, and use a point response
that sends an alarm whether the point is armed or not. For instance, Point Type, page 184 Part
On and Point Response 9 send an alarm on a trouble or a short (I) whether the area is armed
or not.
This parameter affects keyswitch points and suppresses keyswitch (troubles/restorals).
This parameter does not affect local annunciation.
RPS Menu Location
Points > Point Indexes > Local While Disarmed
10.3.17

Local While Armed

Default: No
Selections: Yes/No
–
–
Use this parameter to allow a controlled point (Part On, Interior and Interior Follower), to
report alarms, troubles and restoral reports only when the area is disarmed. This parameter
does not affect local annunciation.
This parameter suppresses all reports from 24-hour points. This parameter only works for
disarmed points, and a a 24 hour "always armed" point. Instead, choose any typeother than
24-Hour, and use a point response that sends an alarm whether the pointis armed or not. For
instance, Point Type Part On and Point Response 9 send an alarm on a trouble or a short (I)
whether the area is disarmed or not.
This parameter affects keyswitch points and suppresses keyswitch (alarms/troubles/restorals)
and D279 (opening/closing/troubles/restorals) Do not use this parameter for controlled points
that arm/disarm.
RPS Menu Location
Points > Point Indexes > Local While Armed
10.3.18

Disable Restorals

Default: No
Selections: Yes/No
–
–
Use this parameter to disable any restoral reports from this point after it returns to normal
from an alarm or trouble event.
Bosch Security Systems, Inc.
Yes. Suppress alarm, trouble and restoral reports from this point while the area it is
assigned to is disarmed.
No. Report events occurring from this point while the area is disarmed.
Yes Suppress alarm, trouble and restoral reports from this point while the area it is
assigned to is armed.
No Report events occurring from this point while the area is armed.
Yes Disable restoral reports for this point.
No Enable restoral reports for this point.
Program Entry Guide
Points | en 195
2017.03 | 09 | F.01U.303.998