Pstn Compatibility; On Board Ethernet (Ip) Communicator; Ipv6 Mode; Ipv4 Dhcp/Autoip Enable - Bosch B9512G Program Entry Manual

Control Panel
Selections:
–
–
When this parameter is set to Yes, the control panel expands test reports to include off-normal
system status information.
The control panel expands manually initiated test reports and Sked initiated (scheduled) test
reports.
RPS Menu Location
Panel Wide Parameters > Phone and Phone Parameters > Expand Test Report
3.1.9

PSTN Compatibility

Default: USA
Selections:
–
–
–
This parameter configures the control panel and the B430 Plug-in Telephone Communicator to
support public switched telephone networks (PSTN) in the USA, Australia, or New Zealand.
Notice!
PSTN requirement for Australia / New Zealand, disable RPS answer armed/disarmed
If you set this PSTN Compatibility parameter to Australia or New Zealand, you must set
Panel Wide Parameters > RPS Parameters > Answer Armed and Answer Disarmed to 0
(disabled).
RPS Menu Location
Panel Wide Parameters > Phone and Phone Parameters > PSTN Compatibility
3.2

On Board Ethernet (IP) Communicator

3.2.1

IPv6 Mode

Default: No
Selections:
–
–
This parameter configures IP communication for IPv6 (Internet Protocol version 6) or IPv4
(Internet Protocol version 4)
When IPv6 Enable is set to Yes, the IPv4 parameters are read only (grayed out and not
editable). Set DHCP/AutoIP enable to Yes.
When IPv6 Enable is set to No, the IPv6 parameters are read only (grayed out and not
editable).
RPS Menu Locations
Panel Wide Parameters > Onboard Ethernet Communicator > IPv6 Mode,
3.2.2

IPv4 DHCP/AutoIP Enable

Default: Yes
Selections:
–
–
Bosch Security Systems, Inc.
Yes - Send expanded test reports.
No - Do not send expanded test reports.
USA
Australia
New Zealand
Yes - Enable IPv6
No - Disable IPv6 (Use IPv4 mode).
Yes - enable DHCP to automatically configure the IP Address, IP Default Gateway, and IP
DNS Server Address.
No - manually configure the IP Address, IP Default Gateway, and IP DNS Server Address.
Use this setting if there is no DHCP service.
Program Entry Guide
Panel Wide Parameters | en
2017.03 | 09 | F.01U.303.998
31