206 en | Points
–
10.4.8
Fire Point
This point type generates a Fire Alarm when an instant alarm response is activated (Refer to
24-hour point response section). Fire alarms are the highest priority event in the control panel.
10.4.9
Aux AC Supervision
This point type monitors the AC power of an auxiliary power supply. When the point is in an
off-normal state, the control panel waits for the time programmed in AC Fail Time before
generating a Point Trouble. This point type does not use Point Response, page 184; therefore,
no alarm event occurs.
If this point type is bypassed, 24 HOUR PT BYPASSED is shown on the keypads.
10.4.10
Gas Point
This point type monitors gas detection sensors and generates a Gas Alarm when an instant
alarm response is activated (Refer to 24-hour point response section).
10.4.11
Custom Function
This point type activates a Custom Function when the CF point response is activated (Refer to
the Custom Function Point response table). The Custom Function activated is configured in
Custom Function parameter.
2017.03 | 09 | F.01U.303.998
Short: The point is disarmed and sends a POINT OPENING. A Point OPening is not sent if
Local Armed is set to Yes.
Program Entry Guide
Control Panel
Bosch Security Systems, Inc.