Table of Contents
Advertisement
Chapter 3 Disassembly and Maintenance
3-1. Maintenance Precautions
3-1. Maintenance Precautions
Before starting disassembly/reassembly or mechanical adjustment, be sure to
disconnect the power cord from the power source. Otherwise, electric shock may occur.
Observe the following in maintenance work:
• Do not disassemble/reassemble or adjust the machine, if it functions properly.
Particularly, do not loosen screws on any component, unless necessary.
• After completing an inspection and before turning on the power, be sure to check that
there is no abnormality.
• Never try to print without media.
• Check that the media is properly set.
• Do not lay anything on the cover or lean against it during maintenance or while the
printer is in operation.
• During maintenance, be careful not to leave parts or screws unattached or loose
inside the printer.
• When handling a printed circuit board, do not use gloves, etc., which can easily
cause static electricity. Since ICs, such as CPU, RAM and ROM, might be destroyed
by static electricity, do not touch lead wires or windows unnecessarily.
• Do not put the printed circuit boards directly on the printer or on the floor.
• When disassembling or reassembling, check wires for any damage and do not pinch
or damage them. Also, run wires as they were.
CL-E700 series
Warning
Caution
3-4
Advertisement
Chapters
Table of Contents
