Citizen CL-E700 series Technical Manual page 75

Submenu Name
[Factory Mode Settings
Menu name]
TT Cold HeatRat
[TT Cold HeatRate Adjust]
DT Hot HeatRate
[DT Hot HeatRate Adjust]
DT Cold HeatRat
[DT Cold HeatRate Adjust]
PwrOn Head Chk
[PowerOn Head Check]
Head Chk Start
[Head Check Start Pos.]
Head Chk Stop
[Head Check Stop Pos.]
Rbn End Detect
[Ribbon End Detection]
Parallel ErrOut
[Parallel Error Output]
USB Serial Num
[USB Serial Number]
Auto Exec Prn
[Auto Exec Print]
Config Print
[Config Print Layout]
Head Clean Msg
[Head Clean Message]
Print Prefer
[Printer Preference]
Adjustable Value
(Default Value)
-1.0 to +1.0% In TT (Thermal Transfer) mode, adjusts the head
(0.0%) temperature compensation coefficient for the
head temperature less than 25C (77F).
To increase the print darkness, increase the
value.
-1.0 to +1.0% In DT (Direct Thermal) mode, adjusts the head
(0.0%) temperature compensation coefficient for the
head temperature 25C (77F) and higher.
To increase the print darkness, increase the
value.
-1.0 to +1.0% In DT (Direct Thermal) mode, adjusts the head
(0.0%) temperature compensation coefficient for the
head temperature less than 25C (77F).
To increase the print darkness, increase the
value.
On/Off Selects whether to perform head check at power
(On) ON or not.
Dots 001 to 848 Designates the start dot for head check.
(Dot 001)
Dots 001 to 848 Designates the end dot for head check.
(Dot 848)
Normal/Slow Selects the time until the ribbon end status is in
(Normal) effect.
On/Off Select whether to activate the Fault signal of
(On) parallel interface at the time of error occurrence
or not.
On/Off Select whether to send the serial number to the
(Off) host or not, when operating the printer through
the USB interface.
On/Off To execute the Auto Exec file stored in the
(On) printer at power ON or not is selectable.
Standard/ Print layout type can be selected.
Reversed Standard: Prints setting items on the left and set
(Standard) values on the right.
Reversed: Prints set values on the left and
setting items on the right.
0 to 9999999 Designates the length where a head cleaning
(0000000m) message is to be printed.
Darkness/Speed To put the priority on printing density or printing
(Darkness) speed is selectable.
2-61
Chapter 2 Operating Principles
2-3.
Operation Panel
Description
CL-E700 series