Sa Ribbon Tension Shaft F" And "Sa Ribbon Sensor; Ribbon Sensor Frame F" Block - Citizen CL-E700 series Technical Manual

3-6-9. "SA Ribbon Tension Shaft F" and "SA Ribbon Sensor"

(1) "Ribbon Sensor Frame F" Block

1. Remove the "SA2 Ribbon Unit Fan". Refer to
2. Remove the 2 screws (BH M3.0x3 (NI)) and detach the "Ribbon Sensor Frame F" Block
from the "SA Ribbon Frame (with Support)".
3. Remove the 2 screws (No0 PH(4-0.3) M2x3 (NI)) and detach the "Cover RBN Tension
Adjust".
4. Peel off the "Label Ribbon Tension Adjust" from the "SA Ribbon Frame (with Support)".
Spring
A
Notes on reassembling:
• Referring to the magnified view, mount the "Cover RBN Tension Adjust" so that the
spring end of the "Ribbon Sensor Frame F" Block is under the "Cover RBN Tension
Adjust".
• Pass the connector J606 through the hole "A" in the frame.
• When remounting the "Ribbon Sensor Frame F" Block, perform the ribbon slant
elimination adjustment. Refer to
(For user)".
• Once the label is peeled off, it cannot be reused.
[Should be under the cover.]
Spring end
J606
"3-7-2(1) Ribbon Left-Right Balance Adjustment Knob
Chapter 3 Disassembly and Maintenance
3-6. Disassembly, Reassembly and Lubrication
"3-6-3 "Unit Ribbon"
BH M3.0x3 (NI)
Cover RBN Tension Adjust
"Ribbon Sensor Frame F" Block
SA Ribbon Frame (with Support)
Label Ribbon Tension Adjust
3-
21
Covers".
No0 PH(4-0.3) M2x3 (NI)
CL-E700 series