Citizen CL-E700 series Technical Manual page 126

Thermal transfer printer
Hide thumbs Also See for CL-E700 series:
Table of Contents

Advertisement

Chapter 3 Disassembly and Maintenance
3-6. Disassembly, Reassembly and Lubrication
Note on reassembling:
When mounting the "SA Head", follow the next procedure.
1. Set the dials as follows.
Media width adjustment dial:
Media thickness adjustment dial: "9"
2. Put the entire "SA Head" Block in the frame and move it to the direction "".
At this time, be sure that the screw "A" is inserted into the slit "B". (If it is not correctly
inserted, the "SA Head" Block cannot be assembled on the frame.)
3. While lightly pressing down the "SA Head" Block (), move it toward the rear () and
hook its rear ends on the 2 claws "C" of the frame.
4. After mounting the "SA Head" Block, set the Media width adjustment dial to "5" to give
tension to the "SA Head" Block.
B
Slit
CL-E700 series
"0" (for easier mounting)
Claw
2
3
1
A
Screw
C
"SA Head" Block
2
3
"0"
(Media Width Adjustment Dial)
"9" to "5"
(Media Thickness Adjusment Dial)
3-40

Advertisement

Chapters

Table of Contents
loading

Table of Contents