Sa Ref Sensor Pcb" And "Spring Adjust Sensor L - Citizen CL-E700 series Technical Manual

3-6-21. "SA Ref Sensor PCB" and "Spring Adjust Sensor L"

1. Remove the "Unit Ribbon". Refer to
2. Remove the "Unit Opepane". Refer to
3. Remove the "Case" and "Cover Steel L". Refer to
4. Remove all connectors from the "SA Main PCB". Refer to
Connectors".
5. Remove the "Unit Mechanism". Refer to
6. Access to the bottom of the "Unit Mechanism", and disconnect the connector of the "SA Ref
Sensor Cable" () from the "SA Ref Sensor PCB".
7. Remove the 1 screw (BH M3.0x4 (NI)) () and detach the "Holder Guide Sensor L" ().
8. Slide the "Guide Paper Set" () to the left, and pull out the "Shaft Sensor Guide" () (with
the "Guide Paper Set" () and "Holder Adjust Sensor L" ()) in the direction of the arrow.
9. Pull out the "Guide Paper Set" () from the "Shaft Sensor Guide" (), and detach the
"Spring Friction Sen PG" and "Plate Friction PG" from it.
10. Pull out the "Holder Adjust Sensor L" () from the "Shaft Sensor Guide" (), and then
detach the following parts.
1) Remove the 2 screws (NO.0 PHT(BT#1) M2.0x3) and detach the "SA Ref Sensor
PCB".
2) Remove the 1 screw (NoO PH(4-0.3) M2x3 (NI)), and detach the "Plate Adj Sen L
Spring" and "Spring Adjust Sensor L".
3) Peel off the "Cover Paper Sensor".
11. Cut the 2 wire ties "Wire Tie" () and remove the "SA Ref Sensor Cable" ().
5 Holder Adjust Sensor L
Plate Adj Sen L Spring
SA Ref Sensor PCB
J8
NO.0 PHT(BT#1)
M2.0x3
7
SA Ref Sensor Cable
Chapter 3 Disassembly and Maintenance
3-6. Disassembly, Reassembly and Lubrication
"3-6-2 Unit Ribbon".
"3-6-10(1) Unit Opepane".
"3-6-11
"3-6-13 Unit Mechanism".
Cover Paper Sensor
NoO PH(4-0.3) M2x3 (NI)
6
Wire Tie
2 Holder Guide Sensor L
3-
45
Case".
"3-6-12(1) "SA Main PCB"
3
Guide Paper Set
Spring Friction Sen PG
Plate Friction PG
Spring Adjust Sensor L
4 Shaft Sensor Guide
1
BH M3.0x4 (NI)
CL-E700 series