Cam Head Balance - Citizen CL-E700 series Technical Manual

(3) Cam Head Balance

1. Remove the "Spring Head L" (short) and "Spring Head R" (long).
2. Remove the "Cam Head Balance" as follows.
1) Set the "Cam Head Balance" (Media width adjustment dial) to "0"and remove the
"Lever Head Balance".
2) Remove the 1 screw (BH M3.0x6 (NI)), and detach the "Cam Head Balance" and
"Pivot Head Balance Cam".
3. Remove the 1 screw (BH M3.0x4 (NI)) and detach the "Holder Guide Sensor U".
4. Peel off the "Label Head Adjust", "Label Head Balance" and "Label Heat Caution" from
the "SA Head Holder Base".
SA Head Holder Base
Notes on reassembling:
• Apply FLOIL G-311S to the following parts marked with "
Pivot Head Balance Cam:
Cam Head Balance: Cam portion
• Once the label is peeled off, it cannot be reused.
Spring Head R
Lever Head Balance
Spring Head L
Surface
Chapter 3 Disassembly and Maintenance
3-6. Disassembly, Reassembly and Lubrication
FLOIL G-311S
BH M3.0x6 (NI)
Pivot Head Balance Cam
Label Heat Caution
Label Head Balance
Label Head Adjust

".
3-
43
Cam Head Balance
Holder Guide Sensor U
BH M3.0x4 (NI)
CL-E700 series