Citizen CL-E700 series Technical Manual page 128

Chapter 3 Disassembly and Maintenance
3-6. Disassembly, Reassembly and Lubrication
Notes on reassembling:
• Insert the end "E" of the "Bracket Head" under the "Spring Head Holder" that is
assembled on the "Cam Head Adjust" Block.
Spring Head Holder
• When mounting the "SA Head", fix it with the 1 screw after fitting its 2 projections to the
guide holes "D" of the frame, as shown on the previous page.
• Clean the thermal element surface of the "SA Head" with the head cleaner.
• After assembling the "SA Head", perform test print in self print mode to check the print
quality. (Refer to
If the print quality is not enough, ribbon slanting or ribbon wrinkle may occur. In this case,
perform "3-7-2 Ribbon Slant Elimination
CL-E700 series
E
End
"Cam Head Adjust" Block
"2-3-2(1) Self print mode".)
Bracket Head
Adjustment".
3-42