Toshiba QOSMIO G10 Maintenance Manual page 86

2 Troubleshooting Procedures
Table 2-6 Debug port (Resume mode) error status (2/4)
LED Status
(F122h)
Check of the checksum of conventional
memory
F123h
Initializing of PCI devices
Check of WakeUp factors after initializing
PCI bus
Waiting for initializing of devices which
F124h
have to be initialized before setting HW
by PnP resource
Recovery of each device (1)
Check of HDD pack connection
Start of IDE device resume sequence
F125h
Recovery of user alarm setting and
cancel of alarm power-on function
Enable of power-off switch
Initializing EC and start of reading battery
information
QOSMIO G10 Maintenance Manual (960-497)
Test item
2.4 System Board Troubleshooting
Contents
Initializing of sound
Acquires the multi-box status.
Initializing of HC, recognizing of USB devices
connection and initializing the USB devices
Control of permission/prohibition for built-in LAN
Resume error DPORT=F174H
Processing of RESUME for PnP
Waiting for the completion of VGA power-down
control (because the VGA configuration can not
be seen)
Processing of RESUME for PCI
Checks slots that were in ON status during
suspending ( for fingerprint identification)
Recovery of PCMCIA card
Error when an ATA card is pulled out
Resume error DPORT=17BH
Executing of dividing process of device detection
of PC card
Resume error when HDD is mounted
DPORT=F172h
(only one time)
2-33