Toshiba QOSMIO G10 Maintenance Manual page 265

4.11 Cover assembly
4. Turning over the computer, remove the following screws securing the cover assembly.
• M2.5×8.0B
5. Disconnect the SD board flat cable from the connector CN9500 on the system board.
6. Disconnect the touch pad flat cable from the connector CN3201 on the system board.
7. Turning up the insulator, disconnect the LE board flat cable from the connector
CN9660 on the system board
8. Disconnect the MDC harness from the connector CN3021 on the system board
M2.5x8.0B FLAT BIND
CN9660
Figure 4-23 Removing the screws & cables (front)
4-36
FLAT BIND screw
MDC harness
CN3021
Insulator
LE board flat cable
4 Replacement Procedures
x3
M2.5x8.0B FLAT BIND
SD board flat cable
CN9500
CN3201
Touch pad flat cable
QOSMIO G10 Maintenance Manual (960-497)