Toshiba QOSMIO G10 Maintenance Manual page 244

4 Replacement Procedures
Installing a HDD
The following describes the procedure for installing a HDD (See Figure 4-4 to 4-6).
1. Install a HDD to the HDD holder and secure it with the following screws.
• M3.0×4.0Z
NOTE: Although they are 3mm head screws, screw torque must be set in 0.294 N·m
(3.0Kgf·cm) for four screws securing the HDD holder.
2. (If a 2nd HDD is installed) Attach a short pin to the connector pin of the 2nd HDD
assembly.
3. Insert the 2nd HDD assembly into the HDD slot from the screw hole side first and
connect it carefully to the PJ1800 on the system board.
4. Secure the 2nd HDD assembly with the following screw.
• M2.5×6.0B
5. Insert the 1st HDD assembly into the HDD slot from the screw hole side first and
connect it carefully to the PJ1880 on the system board.
6. Secure the 1st HDD assembly with the following screw.
• M2.5×6.0B
7. Install the HDD slot cover and secure it with the following screws.
• M2.5×4.0B
QOSMIO G10 Maintenance Manual (960-497)
FLAT BIND screw
FLAT BIND screw
FLAT BIND screw
FLAT BIND screw
4.4 HDD
x4
x1
x1
x 3
4-15