Toshiba QOSMIO G10 Maintenance Manual page 164

3 Tests and Diagnostics
Slide the switch to OFF position. Then, following message appears in the
display.
Slide the switch to ON position. Then, following message appears in the
display.
After Sliding the switch to OFF position, return to the ONLY ONE TEST
menu automatically.
Subtest 05 USB
NOTE: When executing this subtest, USB test module and USB cable must be
connected.
This subtest checks if USB port works properly.
The following menu appears in the display.
#################################################################
########
#################################################################
*
* 0 ............
* 1 ............
* 2 ............
* 3 ............
* 9 ............
*
*****************************************************************
.... Press test number[0-3, 9] ?
Connect the USB test module and USB cable to the computer.
Input the port test number and press Enter.
OK message appears in the display if the test ends without a defective.
NG message appears in the display if a defective is found during the test.
Confirm the connection of cable, then execute the test again.
Press 9 and return to ONLY ONE TESST menu.
QOSMIO G10 Maintenance Manual (960-497)
KILL SWITCH ON !!
KILL SWITCH OFF !!
ONLY ONE TEST Menu (XXXXXXXXX)
Port 0
Port 1
Port 2
Port 3
EXIT
3.20 ONLY ONE TEST
#######
3-43
*
*
*
*
*
*
*