Optical Disk Drive - Toshiba QOSMIO G10 Maintenance Manual

4.9 Optical disk drive

4.9 Optical disk drive
NOTE: Do not apply excessive force to the top of an optical disk drive.
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
Removing an optical disk drive
The following describes the procedure for removing an optical disk drive (See Figure 4-13
and 4-14).
1. Turn over the computer and remove the following screws securing an optical disk
drive.
•
2. Inserting a blunt-edged tool from the slot, disconnect an optical disk drive toward
the arrow direction from the connector CN1810 on the system board.
CN1810
4-26
M2.5×4.0B FLAT BIND screw
Slot
Figure 4-13 Removing an optical disk drive
4 Replacement Procedures
x2
Optical disk drive
M2.5 x 4.0B FLAT BIND
QOSMIO G10 Maintenance Manual (960-497)