Toshiba QOSMIO G10 Maintenance Manual page 306

4 Replacement Procedures
Installing the LCD unit/FL Inverter
The following describes the procedure for installing the LCD unit and FL inverter (See
Figure 4-52 to 4-55).
1. Install the LCD supports (LCD unit side) to the LCD and secure them with the
following screws.
•
2. Stand the LCD unit on the display cover and connect the LCD harness to the
connector on the back of LCD.
3. Stick the copper tape on the connector of LCD harness.
4. Secure the LCD unit with the following screws.
•
5. Connect LCD harnesses to the connector CN1 and CN2 of the FL inverter.
CAUTION: Be careful not to connect the LCD harnesses to the wrong connectors of FL
inverter.
6. Connect HV harnesses to the connector CN3 and CN4 of the FL inverter.
7. Insert one insulator under the LCD unit with the HV harnesses folded and stick the
other one to the FL inverter.
8. Install the FL inverter while sticking the double-sided tape and secure it with the
following screw.
•
9. Install the display mask while fitting the latches.
NOTE: When installing the display mask, make sure there is no gap between the display
mask and the display cover.
QOSMIO G10 Maintenance Manual (960-497)
M2.0×3.0C SUPER THIN HEAD screw
M2.0×5.0C SUPER THIN HEAD screw
M2.0×5.0C SUPER THIN HEAD screw
4.27 LCD unit / FL inverter
x6
x6
x1
4-77