Toshiba QOSMIO G10 Maintenance Manual page 242

4 Replacement Procedures
5. (If a 2nd HDD is installed) Remove the following screw securing the 2nd HDD
assembly.
• M2.5×6.0B
6. Disconnect the 2nd HDD assembly from the connector CN1800 on the system board.
HDD slot cover
7. Remove the short pin from the connector pin of the 2nd HDD.
QOSMIO G10 Maintenance Manual (960-497)
FLAT BIND screw
M2.5x4.0B FLAT BIND
Figure 4-4 Removing the HDD assembly
Figure 4-5 Removing the short pin
4.4 HDD
x１
M2.5x6.0B
FLAT BIND
Short pin
4-13