Toshiba QOSMIO G10 Maintenance Manual page 256

4 Replacement Procedures
3. Remove the following screws securing the side bracket and remove it from an
optical disk drive.
• M2.0×3.0C
•
Stepping screw
Installing an optical disk drive
The following describes the procedure for installing an optical disk drive (See Figure 4-13
and 4-14).
1. Attach the side bracket to an optical disk drive and secure it with the following
screws.
• M2.0×3.0C
•
2. Insert an optical disk drive assembly into the slot and connect it to the connector
CN1810 on the system board.
3. Turn over the computer and secure an optical disk drive with the following screws.
• M2.5×4.0B
QOSMIO G10 Maintenance Manual (960-497)
SUPER THIN HEAD screw
M2.0×3.2B Stepping screw
Figure 4-14 Disassembling the side bracket
SUPER THIN HEAD screw
M2.0×3.2B Stepping screw
FLAT BIND screw
4.9 Optical disk drive
x2
x1
Side bracket
M2.0×3.0C SUPER THIN HEAD
x2
x1
x2
4-27