Us Board - Toshiba QOSMIO G10 Maintenance Manual

4.18 US board

4.18 US board
Removing the US board
The following describes the procedure for removing the US board (See Figure 4-36).
1. Disconnect the USB harness from the connector CN4621 on the US board.
2. Remove the following screw securing the US board and remove the US board.
• M2.5×4.0B
USB harness
Installing the US board
The following describes the procedure for installing the US board (See Figure 4-36).
1. Install the US board and secure it with the following screw.
• M2.5×4.0B
2. Arranging the USB harness along the guide, connect the USB harness to the
connector CN4621 on the US board.
4-54
FLAT BIND screw
CN4621
guide
Figure 4-36 Removing the US board
FLAT BIND screw
4 Replacement Procedures
x1
M2.5x4.0B FLAT BIND
US board
x1
QOSMIO G10 Maintenance Manual (960-497)