Toshiba QOSMIO G10 Maintenance Manual page 287

4.19 Speaker (R) / TJ board
3. Arranging the TJ board cable along the guide, connect it to the connector CN9614
on the TJ board.
4. Arrange the USB harness along the guide.
5. Install the harness holder and secure it with the following screw.
• M2.5×4.0B
NOTE: When installing the harness holder, be careful not to catch cables.
6. Arrange the DC-IN cable along the guide of harness holder and install the DC-IN
jack in the slot of base assembly.
7. Fix the DC-IN cable with the glass tape.
4-58
Figure 4-39 Cable arrangement in guide
FLAT BIND screw
4 Replacement Procedures
TJ board cable
USB harness
x1
QOSMIO G10 Maintenance Manual (960-497)