Toshiba QOSMIO G10 Maintenance Manual page 281

4.16 RTC battery / BT board
Installing the BT board
The following describes the procedure for installing the BT board (See Figure 4-34).
1. Connect the battery harness to the connector CN9690 on the BT board and to the
connector CN8020 on the system board.
2. Install the BT board and secure it with the following screw.
• M2.5×6.0B
3. Connect the BT board flat cable to the connector CN9691 on the BT board and to
the connector CN8021 on the system board.
4. Install the battery connector cover and secure it with the following screw.
• M2.5×6.0B
4-52
FLAT BIND screw
FLAT BIND screw
QOSMIO G10 Maintenance Manual (960-497)
4 Replacement Procedures
x1
x1